RC Helicopter Blade Tracking

RC helicopter blade tracking has a secret, many new owners of RC helicopters have been, but I will do everything for you at this time concept in order to demystify a complete understanding of the alignment with the time you read this finished product.

First we have to answer this important question: What is blade tracking?

Rc Helicopter

In essence, the monitoring of the blade is when a rotor blade rotates in a circular motion and the blade follows closely behind. Both blades rotateat the same level, without a blade is higher or lower blade, follows him. Another way is to see things that both blades travel through the same air space created by their spinning. If the blade is under the rear of the plow blade to a higher or lower, then a lot of unwanted vibrations for the RC helicopter.

How to keep the blades

If your RC helicopter used for the first time, you have to see if the blades are tracking correctly and you canneed some help from an experienced RC helicopter pilot. You can run the track instead of simply passing helicopter at eye level and see how it floats to control the wings. If you see a lot of shaking and vibrating, it is your RC helicopter is more than likely not properly aligned. If you are not sure if it is properly registered to do this:

Take two different colors of tape and apply a small strip of color on a leaf. Put a red stripe on a paper and a blue stripe on the otherBlade. Using a different color on each sheet makes it much easier to see, follow what your hand to no longer work.

Now that you have applied the colored ribbon, an experienced helicopter pilot RC helicopters hover so that you can see how the leaves spin. As you can see the blades rotate, you know, if they get in the way, if you use a single circle or two leaves run on a line. If you have two circles or two lines, see (above, red, blue or vice versa), then you know thatone of the blades are turned off and must be aligned.

In order to pursue the cutting blades, you have a floating floor RC helicopter before. The spiders have stopped after the knife, you can use the blade, the outer part of the track. You need your RC helicopter manual handy so that you look at the correct information for monitoring of the blade are in him. Be sure to adjust the correct association as the manual says and not what someone says. This is the best way to ensure thatproperly done.

Once you tighten or loosen the correct link or links, you need someone to fly the helicopter back, so watch the knives. Repeat this as many times as necessary until your hands are properly set and maintain the same level position. As soon as you complete proper monitoring of the blade, the handle RC helicopter is much smoother than before and much easier to fly.

RC Helicopter Blade Tracking

x files the complete